Raise3D Industrial PPA Support Filament Purple 1kg (1.75mm)
Raise3D PPA Support
A break-away support material designed for the composite filaments based on PPA.
Raise3D Industrial PPA (Polyphthalamide)Support Filament is a break-away support material specially developed for PPA (Polyphthalamide). During 3D printing process, it creates a stable support structure, provides proper adhesion to interface with printed parts, and counteract with the warpage tendency, therefore it improves the surface quality for overhangs and cavities of the printed parts significantly; After a print is finished, the support structure can be easily removed (break-away) by hands or tools from the printed parts. This support material is more cost-effective comparing with water-soluble support material.
- Cost effective
- Easy to remove and break-away
- No special treatments
Compatibility: Raise3D Industrial PPA CF, Raise3D Industrial PPA GF Filament
It is recommended to use hardening steel nozzle and above grade nozzles.
Applications
- Support material for Raise3D Industrial PPA CF and PPA GF Filament.
Material Performance
Printing Guide
Recommended Print Settings

Nozzle temperature (°C)
280℃-290℃

Bed temperature (°C)
60-80℃

Layer height (mm)
0.1-0.25 mm (0.4mm nozzle)

Printing speed (mm/s)
30-90 mm/s

Cooling fan
OFF

Drying temperature (°C)
80-100℃ for 4-6 hours
Printing Notifications:
- It is recommended to use hardening steel nozzle and above grade nozzles.
- Raise3D Industrial PPA Support Filament is sensitive to moisture and should always be stored and used under dry conditions (relative humidity below 15%).
Title | Raise3D Industrial PPA Support Filament Purple 1kg (1.75mm) |
---|---|
Manufacturer | Raise3D |
Base Material | Break-Away |
Difficulty | Intermediate |
Nozzle Temperature | 280℃ - 290℃ |
Heated Bed Required? | Yes |
Print Bed Temperature | 60°C - 80°C |
Bed Adhesion | Glass Plate, Tape, Buildtak, PEI |
Enclosure Required? | Recommended |
Nozzle Size | ≥ 0.4mm |
Print Speed | 30 - 90 mm/s |
Fan Speed | Off |
Retraction | ± 5mm |
Drying | 80 - 100°C for 4 to 6 hours |
Minimum Nozzle Temp | 280ºC |
Dimensional Accuracy | < +/- 0.05mm |
Other Recommendations | It is recommended to use hardening steel nozzle and above grade nozzles |
MPN | [S]5.11.19011A01 |
Diameter | 1.75mm |