Raise3D Industrial PPA CF Filament Black 1kg (1.75mm)
Raise3D PPA CF
A high-performance composite filament for end-use applications
Raise3D Industrial PPA CF Filament is carbon fiber reinforced composite filament material based on PPA (polyphthalamide or high-performance/high-temperature Nylon). Thanks to its high performance Nylon matrix, this composite filament has superior mechanical and thermal properties than other Nylon filaments. With well controlled dispersion and length-distribution of chopped carbon fibers (15 wt.%), the PPA CF has lower density, lower moisture absorption, high strength and rigidity, high wear and creep resistance, excellent chemical and heat resistance. It is promising for end-use applications in automotive, aerospace, electrical and electronics (E&E) industry.
- High rigidity and strength
- Better thermal performance
- Lower moisture absorption
- Dimensional stability
- Chemical resistance
- High strength-to-weight ratio
Compatibility: Raises3D Industrial PPA Support Filament
Applications
- Automobile
- Aerospace
- Electrical and electronics (E&E) industry
- Industrial end-use parts
Material Performance
Printing Guide
Recommended Print Settings

Nozzle temperature (°C)
290-310℃

Bed temperature (°C)
65-80℃

Layer height (mm)
0.1-0.25 mm

Printing speed (mm/s)
30-120 mm/s

Cooling fan
OFF

Drying temperature (°C)
80-100°C for 4 to 6 hours
Printing Notifications:
- Abrasion of the brass nozzle happens frequently when printing PPA CF. Using abrasion resistance nozzle, as hardened steel and above grade nozzle is highly recommended.
- After the printing, it is recommended to anneal the model with support material in the oven at 80-100°C for 8 to 12 hours to improve mechanical property and dimensional accuracy.
Title | Raise3D Industrial PPA CF Filament Black 1kg (1.75mm) |
---|---|
Manufacturer | Raise3D |
Base Material | Carbon Fiber Nylon |
Difficulty | Intermediate |
Nozzle Temperature | 290℃ - 310℃ |
Heated Bed Required? | Yes |
Print Bed Temperature | 65°C - 80°C |
Enclosure Required? | Recommended |
Nozzle Size | ≥ 0.4mm |
Print Speed | 30 - 120 mm/s |
Spool Weight | 1 KG |
Drying | 80 - 100°C for 4 to 6 hours |
Minimum Nozzle Temp | 290ºC |
Dimensional Accuracy | < +/- 0.05mm |
Other Recommendations | After printing, it is recommended to anneal the model with support material in the oven at 80-100°C for 8 to 12 hours to improve mechanical property and dimensional accuracy. |
MPN | [S]5.11.19007A01 |
Diameter | 1.75mm |